Ολα
Λέξεις-κλειδιά προϊόντος
Εισαγωγή της διεύθυνσης e-mail του λογαριασμού

Αξιολογήσεις πελατών

4.93 out of 5
  • 13
  • 1
  • 0
  • 0
  • 0
Γράψτε μια αξιολόγηση
  • Timothy
    Perfect for Fan Speed controlled 3D printing
    These fans allow setting fan speed in slicer software or 3D printer control panel. There is a bit of an annoying whine at lower speeds but it is usually drowned out by noise from other fans or stepper motors.

    Apr 05,2019

  • Prisoner
    Great 3D printer cooling fan.
    These fans put out so much air I had to re-design the fan shroud on the effector because the fan was cooling off the heat block and causing a thermal runaway.

    Mar 25,2019

  • Kirk B.B
    So Far So Good!
    Powerful little fans. My controller can be actively cooled quietly without tripping any thermal protections so I can push it near it's full load all day.

    Mar 26,2019

  • Erik T.
    Great air output
    I'm using these fans for part cooling on a 3D printer. They put out a lot of air, much more than some similar fans I was using before.

    Feb 19,2019

  • Darryl Felder
    Awesome alfawise radial blower.
    Perfect fit after printing a fang mount. Tested it conducted several bridging test, worked better than expected.

    Mar 29,2019

  • seigafolava
    Great. Quiet
    I would like to mention that I replaced the original fan on my printer with this and this fan works much better.

    Apr 01,2019

  • Wolfgang
    Five Stars
    Smoother than the stock blowers and is a direct replacement.

    Feb 23,2019

  • Andrea
    Ventola di raffreddamento
    Ventola di raffreddamento 40x40x10 di scorta per la mia stampante 3D Alfawise U20. Ho acquistato un po di accessori originali soggetti a usura almeno li ho di scorta. Ok.

    Aug 22,2019

  • alessandro
    perfetto
    prodotto perfetto, di ottima qualità, arrivato in anticipo, già messo in funzione da diversi giorni nessun difetto, consigliatissimo

    Dec 15,2019

  • D. Steager
    Nice Alfawise Fans
    Nice Alfawise Fans. My cooling fan for printer builds.

    Mar 17,2019